YOK130MGI-Q1 1.3inch OLED Module SH1106 Display with 128x64 Resolution IIC Interface for STM32, C51,Arduino, Raspberry Pi and MSP430 platforms

• • 1.3 inch OLED screen with black and white or black and blue color display
  • 128x64 resolution for clear display and high contrast
  • Large viewing angle: greater than 160° (one screen with the largest viewing angle in the display)
  • Wide voltage supply (3V~5V), compatible with 3.3V and 5V logic levels, no level shifting chip required
  • With IIC bus, only a few IOs can be used to light up the display
  • Ultra-low power consumption: normal display is only 0.06W (far below the TFT display)
  • Military-grade process standards, long-term stable work
  • Provides a rich sample program for STM32, C51, Arduino, Raspberry Pi and MSP430 platforms
  • Provide underlying driver technical support

NOTE:

1.This module supports IIC slave device address switching (shown in red box in Picture 4), as follows:

A.Solder the 0x78 side resistance, disconnect the 0x7A side, then select the 0x78 slave address (default);

B.Solder the 0x7A side resistance, disconnect the 0x78 side, then select the 0x7A slave address;

2.The hardware switches the IIC slave device address, and the software also needs to be modified accordingly.

For details, see the test program description document or the user manual..

important:

1. The following pin numbers 1~7 refer to the module pin number of our company with PCB backplane. If you

purchase a bare screen, please refer to the pin definition of the bare screen specification, refer to the wiring

according to the signal type instead of directly according to the following. The module pin number is used for wiring.

2. About VCC supply voltage: The OLED display module can be connected to 3.3V or 5V.